Webster IRP 4500 Installationsanleitung PDF herunterladen (Seite 28)

Interactive Rear Projection (IRP)

26 INSTALLING THE IRP 4500

a If the projected image is wider at the top of the screen, lower

the front of the projector using the height adjustment knob

on the projector.

b If the projected image is wider at the bottom of the screen,

raise the front of the projector slightly.

Refer to the documentation that came with your projector for

specific instructions on how to adjust the projector height.

9 Repeat steps five through eight as many times as may be

necessary to get both sides of the projected image square and

located within 0.2” (5mm) of the edges of the IRP screen at both

the top and the bottom of the image.

10 If necessary, eliminate horizontal keystoning as follows. If not,

go to step twelve.

a Locate the horizontal keystone knob on the projector plate

at the rear of the console. The knob is labeled as shown

below).

b To unlock the plate that supports the projector, rotate the

knob counter-clockwise.

c If the projected image is wider on the left, push the front of

the projector slightly to the left.

d If the projected image is wider on the right, push the front of

the projector plate slightly to the right.

IRP_Install_1.fm Page 26 Monday, February 3, 2003 4:19 PM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Keine Kommentare

Webster IRP 4500 Installationsanleitung Seite 28